Siemens SITRANS FX330 - Page 86

6 OPERATION
86
SITRANS FX330
www.siemens.com/flow 08/2022 - A5E36751269-AG EN
Function Setting / Description
C4 Totalizer (4...20 mA/HART version)
C4.1 Flow Totalizer
C4.1.1 Measurement Select: Volume Flow / Norm. Volume Flow / Mass Flow
"Norm. Vol." is only available if fluid is "Gas", "Wet Gas" or "Gas Mixture".
C4.1.2 Preset Value Set value, which triggers signal on status output (refer to C2.2.4.1).
C4.1.3 Reset Totalizer? Select: Yes / No
C4.1.4 Set Start Value Set start value in selected unit.
Start value has to be confirmed with "Yes" or refused with "No".
C4.1.5 Start Totalizer? Select: Yes / No
C4.1.6 Stop Totalizer? Select: Yes / No
C4.1.7 Information Display of current totalizer values.
The menus C4.1.7.1 to C4.1.7.3 are available depending on selected measurement
variable in C4.1.1.
C4.1.7.1 Volume Display of current totalizer value for volume flow.
C4.1.7.2 Norm. Volume Display of current totalizer value for norm. volume flow.
C4.1.7.3 Mass Display of current totalizer value for mass flow.
C4.2 Energy Totalizer
This menu is available for meter types ≠ "Standard" and for medium = "Steam" or
"Water".
C4.2.1 Measurement Select: Gross Energy / Net Energy
"Net Energy" is only available, if fluid = "Steam" or medium = "Water".
C4.2.2 Preset Value Set value, which triggers signal on status output.
C4.2.3 Reset Totalizer? Select: Yes / No
C4.2.4 Set Start Value Enter current value in selected unit.
Start value has to be confirmed with "Yes" or refused with "No".
C4.2.5 Start Totalizer? Select: Yes / No
C4.2.6 Stop Totalizer? Select: Yes / No
C4.2.7 Information Display of current totalizer values.
The menus C4.2.7.1 and C4.2.7.2 are available depending on selected measurement
variable in C4.2.1.
C4.2.7.1 Gross Energy Display of current totalizer value for gross energy.
C4.2.7.2 Net Energy Display of current totalizer value for net energy.
Table 6-32: Menu description C4
Function Setting / Description
C5 Display
C5.1 Language For availability of display languages refer to Menu languages on page 62.
C5.2 Contrast Adjust contrast of local display (-10...+10).
C5.3 1. Meas. Page Configuration of the first measurement display page.
C5.3.1 Function Select: One Value / Two Values / Three Values / One Value & Bargraph / Two Values &
Bargraph