Siemens SITRANS LR100 - Mounting instructions

Installing/mounting
4.3Mounting instructions
Figure4.1 Mounting via a mounting bracket
4.3 Mounting instructions
Installation position
When mounting the device, keep a distance of at least 200mm (7.874in) from the
vessel wall. If the device is installed in the center of dished or round vessel tops,
multiple echoes can arise. However, these can be suppressed by an appropriate
adjustment (see chapter ""Setup").
If you cannot maintain this distance, you should carry out a auto false echo
suppression during setup. This applies particularly if buildup on the vessel wall is
expected. In such cases, we recommend repeating the auto false echo suppression at
a later date with existing buildup.
Figure4.2 Mounting of the radar transmitter on round vessel tops
Reference point
The centre of the antenna lens is the beginning of the measuring range and at the
same time the reference point for the min./max. adjustment, see following diagram:
12
SITRANS LR100
Operating Instructions, 10/2021, 62705-76-01