Siemens SITRANS LR150 - Page 37

Setup with the integrated HMI
7.2Structure and views of the display
Setting Description
P8 STEMP Electronics temperature
a
If the mode of operation is set accordingly
b
If the mode of operation is set accordingly
Note
If the measured value cannot be shown in the display, " 99999" appears flashing.
In this case the selected unit or scaling must be adapted.
Parameter view
The parameter view shows the parameters, parameter values and the wizards of the
device.
1
Parameter name
2
Parameter value
3
Parameter number
4
EDIT" symbol (permanently activated)
Figure7.4 Parameter view
Editing view
Parameter values can be changed in this view. Wizards are available for certain
parameters.
Note
While the device is in the editing view, the output remains active and continues to
respond to changes.
1
Parameter name
2
Unit of the measured value (no. 1 and 2 are displayed alternately)
3
Arrows for scrolling (only within an option list)
4
Parameter number
28
SITRANS LR150
Operating Instructions, 08/2020, A5E50352155