Page 52 SITRANS LR250 (PROFIBUS PA) – INSTRUCTION MANUAL 7ML19985JF02
mmmmm
Parameters
Quick Start Wizard
The Quick Start wizard groups together all the settings you need to configure for a simple
application. You can access it either via SIMATIC PDM or via the handheld programmer.
• Do not use the Quick Start wizard to modify individual parameters. (Perform
customization only after the Quick Start has been completed.)
• Each time the Quick Start Wizard is initiated, the start-up settings are factory
defaults. The Wizard will not recall previous user-defined settings.
• For more details see
Quick Start Wizard via the handheld programmer
on page 30
or
Quick Start
on page 36 for setup via SIMATIC PDM.
1. Quick Start
1.1. Material
1.2. Response Rate
1.3. Units
1.4. Operation
1.5. Low Calibration Point
1.6. High Calibration Point
1.7. Apply? (Apply changes)
2. Setup
2.1. Device
2.1.1. Tag
Text that can be used in any way. A recommended use is as a unique label for
a field device in a plant. Limited to 32 ASCII characters.
Simulation 46
Device Status 50
Device Status 50
Write Locking 48
Toolb ar
Status bar
Update
a)
Visible only after an echo profile has been saved.
Note: For detailed instructions see
Quick Start Wizard via the handheld programmer
on page 30 or
Quick Start Wizard via SIMATIC PDM
on page 36.
Notes:
• See
Programming via the handheld programmer
on page 27 or
Operating via
SIMATIC PDM
on page 34 for instructions.
• Default settings in the parameter tables are indicated with an asterisk (*) unless
explicitly stated.
• Values shown in the following tables can be entered via the handheld programmer.
Device menus page View menus (cont’d) page
To Next Page
Loading...
