Page 58 SITRANS LR250 (PROFIBUS PA) – INSTRUCTION MANUAL 7ML19985JF02
mmmmm
Parameters
2.2.2.3. Max Volume
The maximum volume of the vessel. Units are defined in PV (volume/level)
Units. The volume calculation is based on the maximum volume and scaled
according to the vessel shape selected. If no vessel shape is entered, the
default is 100, and the reading will be a percentage value.
For readings in volumetric units instead of percentage values:
a) Select a volumetric unit from PV (volume/level) Units.
b) Enter the vessel volume corresponding to High Calibration Point.
2.2.2.4. Dimension A
The height of the vessel bottom in Level Units for any vessel shape that
does not have a flat bottom. See Vessel Shape (2.2.2.2.) for an illustration.
2.2.2.5. Dimension L
Length of the cylindrical section of a horizontal parabolic end vessel, in
Level Units. See Vessel Shape (2.2.2.2.) for an illustration.
2.2.2.6. Volume breakpoints
Allows you to define a complex vessel shape as a series of segments.
A value is assigned to each level breakpoint and a corresponding value is
assigned to each volume breakpoint.
Volume values are defined in volume units and can be percent or
volumetric; level values are defined in level units, and can be
percent or linear.
1)
2)
Values
Range: 0.0000 to 999999
Default: 100.0
Related Parameters
Low Calibration Pt. (2.2.1.4.)
High Calibration Pt. (2.2.1.5.)
Vessel Shape (2.2.2.2.)
Values
Range: 0.0000 to 999999 in Level Units
Default: 0.0
Related Parameters
Vessel Shape (2.2.2.2.)
Values
Range: 0.0000 to 999999 in Level Units
Default: 0.0
Related Parameters
Vessel Shape (2.2.2.2.)
Note: This parameter becomes accessible only after Linearization Table
has been selected in Vessel Shape (2.2.2.2.)
To Next Page
Loading...
