Siemens Sitrans LR250 - Remote Operation; Operating via SIMATIC PDM

7ML19985JF02 SITRANS LR250 (PROFIBUS PA) – INSTRUCTION MANUAL Page 69
mmmmm
Parameters
2.2.7.2. Output, no linearization (SV1 – Secondary Value 1)
The value for level.
In SIMATIC PDM, open the menu View – Display, and select the tab
Measured Value (Secondary Values). Refer to Level field.
2.2.7.3. Output, no level offset (SV2 – Secondary Value 2)
The value for distance.
In SIMATIC PDM, open the menu View – Display, and select the tab
Measured Value (Secondary Values). Refer to Distance field.
2.3. Output
2.3.1. AIFB1
Static Revision No.
The revision level of the static data associated with Analog Input Function
Block 1. The Static Revision No. is updated whenever a configuration
parameter is changed.
2.3.1.1. Target Mode
Used to request an operating mode from the Analog Input Function Block.
Allows you to put the SITRANS LR250 into Out of Service Mode and then
reset it to Automatic Mode.
Manual Mode is used in conjunction with Simulation. See
Simulation on
page 46. It should be used only with SIMATIC PDM in order to benefit from
all the features available.
2.3.1.2. Label
User defined label
2.3.1.3. Unit
Engineering unit to be displayed with the output value
Note: Default settings in the parameter tables are indicated with an asterisk (*)
unless explicitly stated.
Options
Automatic Mode (AUTO)
Manual Mode (MAN)
Out of Service (O/S)
Note: Additional units are available in SIMATIC PDM.
Options
m, cm, mm, ft, in, cu m, L, HL, cu in, cu ft, cu yd, gal, imp gal,
bushels, Bbl, Bbl liquid, percent, PA, Follow out unit
*
percent