Siemens SITRANS LR500 Series - Radar Frequencies for Worldwide Use

WARNING
Signal wiring
In
put/output connections to the transmitter are required to be protected by intrinsic safe
barriers at all times.
WARNING
Equipment used in hazardous areas
Eq
uipment used in hazardous areas must be Ex-approved for the region of installation and
marked accordingly. It is required that the special conditions for safe use provided in the
manual and in the Ex certi󹪝cate are followed!
3.6 Radar frequencies for worldwide use
Countr
y speci󹪝c settings for the radar signals are determined via the frequency. The operating
mode must be set in the operating menu via the respective adjustment tool at the beginning of
the setup. For more information, see Parameter assignment (Page113)
WARNING
Selecting the frequency for your country group
Oper
ating the device without selecting the frequency for the appropriate country group
constitutes a violation of the regulations of the radio approvals of the respective country.
Safety notes
3.6Radar frequencies for worldwide use
SITRANS LR500 series with mA/HART
24 Operating Instructions, 03/2024, A5E51099898-AA