Siemens SITRANS LR500 Series - Requesting an Echo Profile; Device Address Configuration

7.6.5 Requesting an echo pr
o󹪝le
Procedure
After commissioning the device, an echo pro󹪝le may be viewed on the HMI or using a remote
engineering system, such as SIMATIC PDM.
For details, see SIMATIC PDM (Page207).







① X-axis: Distance
Dis
tance units can be set to: m, cm,
mm, ft, in.
⑤ Algorithm used
2)
② Y-axis: Echo amplitude (in dB) ⑥ Echo
③ Distance from sensor face to target ⑦ TVT
3)
④ Echo con󹪝dence
1)
 
1)
See Con󹪝dence (P
age202)
2)
See Auto false echo suppression and Custom TVT (Page202)
3)
Where AFES has been learned, AFES curve replaces TVT curve (see Auto false echo suppression
(Page98) ).
1. In measurement view, press
to navigate to parameter view Maint. and diag.
Diagnos
tics
Ec
ho pro󹪝le (3.2.1) (Page130).
2. Press
to start wizard and request a pr
o󹪝le.
3. To update to current pro󹪝le, press
and
4
. To exit and return to the previous menu, press
button.
7.6.6
Device address
Setting a device address is not necessary for local operation, but must be set if con󹪝guring the
device for use on a HART network. See Polling address (4.1) (Page145).
Commissioning
7.6Local commissioning
SITRANS LR500 series with mA/HART
Operating Instructions, 03/2024, A5E51099898-AA 83