Siemens SITRANS LUT400 Series - Setting a Pump up (Reservoir) Group

A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 85
mmmmm
General Operation
Setting a pump up (reservoir) group
Sets a group of two pumps to pump up a reservoir.
Set the common parameters
Prerequisite: Substitute the details of your application in place of the sample values
provided. If you are bench testing the device, set your test values to be the same as the
sample values.
Set Relays to ALTERNATE DUTY ASSIST (ADA)
Parameter Sample Value
2.1.2. Sensor Mode or 2.1.3. Sensor Mode Level
Response Rate Medium
2.1.6. Transducer XPS-10
2.1.1. Units M
2.2.1. Low Calibration Point 1.8
2.2.2. High Calibration Point 0.4
Parameter Value Description
2.7.1.4. Pump Control Mode
or
2.7.1.5. Pump Control Mode
ADA Sets the control algorithm used to trip the pump
relay to ALTERNATE DUTY ASSIST.
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
SITRANSLUT400
Low Cal. Pt.
High Cal. Pt.
inflow
outflow
SITRANS LUT400
sensor ref. point
level
*
**
* ON Setpoint Pump 1 / Pump 2
** OFF Setpoint Pump 1 / Pump 2
Setpoint sample values:
(see tables below)