A5E33701270 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL Page 7
mmmmm
Operation - PDM
Configuring a new device
1) Check that you have the most recent EDD, and if necessary update it (see
To install a
new EDD
above).
2) Configure the device using the Quick Start Wizard. See
Quick Start Wizard via
SIMATIC PDM
on page 7.
Before initiating a Quick Start Wizard to configure the device, you may wish to gather the
necessary parameter values. Parameter Configuration Charts listing all parameters and
available options for each application type are available on our website. Go to:
www.siemens.com/sitransLUT400
> Support > Application Guides. You can record data
and select from options on the chart that apply to your application, then complete the
Quick Start Wizard via SIMATIC PDM
on page 7.
Quick Start Wizard via SIMATIC PDM
The graphic Quick Start Wizard provides an easy step-by-step guide to help you
configure the device for a simple application.
Please consult the operating instructions or online help for details on using SIMATIC
PDM. (Application Guides for setting up Siemens HART instruments with SIMATIC PDM
are available on our website: www.siemens.com/processautomation
.)
1. If you have not already done so, check that you have the most up-to-date Electronic
Device Description (EDD) for your instrument. (See
Configuring a new device
on
page 7.)
2. Launch SIMATIC Manager and create a new project for LUT400. (Application Guides
for setting up HART devices with SIMATIC PDM can be downloaded from the
product page of our website at www.siemens.com/sitransLUT400
.)
Notes:
• The first time the device is configured, you will be prompted to select a language
(English, German, French, Spanish, Chinese, Italian, Portuguese, or Russian). To
change the language again, use Language parameter [see
Parameter reference
(LUI)
in LUT400 operating instructions
a
].
• Clicking on Cancel during an upload from device to SIMATIC PDM will result in some
parameters being updated.
• Application Guides for setting up HART devices with SIMATIC PDM can be
downloaded from the product page of our website at:
www.siemens.com/sitransLUT400
.
a.
SITRANS LUT400 (HART) Operating Instructions (7ML19985MV01)
Note: The layout of the dialog boxes shown may vary according to the resolution
setting for your computer monitor.
To Next Page
Loading...
