A5E33701270 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL Page 23
mmmmm
Operation - PDM
Step 2 – Vessel Regime
1) Select the Pump Control Mode.
2. If Service Ratio Duty Assist, or Service Ratio Duty Backup selected enter the Service
Ratio for each pump.
3. Click on Next.
Step 3 – Pump Setpoints
1) Enter the start level (ON Setpoint), and stop level (OFF Setpoint) for each pump, then
click on Next.
Step 4 – Summary
1. Check parameter settings, and click on Cancel to abort, or apply your changes.
To Next Page
Loading...
