Page 24 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL A5E33701270
mmmmm
Operation - PDM
2. Click Apply to save your changes and return to the main menu, or click Apply and
Transfer to save your changes and transfer settings to the device.
Pump configuration via PDM Pump Control Wizard is now complete.
Changing parameter settings using SIMATIC PDM
Many parameters are accessed via the 5-level menu in PDM. See
Parameters accessed via
pull-down menus
below for the others.
1) Launch SIMATIC PDM, connect to SITRANS LUT400, and upload data from the
device.
2) Adjust parameter values in the parameter value field and then press Enter. The
status fields read Changed.
Notes:
• For a complete list of parameters, see
Parameter reference (LUI)
in LUT400 operating
instructions
a
.
• Clicking on Cancel during an upload from device to SIMATIC PDM will result in some
parameters being updated.
a.
SITRANS LUT400 (HART) Operating Instructions (7ML19985MV01)
To Next Page
Loading...
