Page 46 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL A5E33701270
mmmmm
Operation - Browser
Browser Menu Parameter Function Groups
Notes:
• Below is a list of parameter function groups (not individual parameters) available on the
browser. A parameter number is referenced for more information on the parameters within
each function group.
• An asterisk (*) in the left column means this parameter or function group will not display
on the browser menu unless the SITRANS LUT400 is configured for Pump and Flow* or
OCM* at startup, and the device connected supports this functionality.
*
Parameter Function Group
Parameter
Number
I
DENTIFICATION
3.1
Device
SETUP
2
Sensor 2.1
Calibration 2.2
Rate 2.3
Fail-Safe 2.4
Current Output 2.5
Current Output Function
Current Output Setup
Volume 2.6
Level and Volume Breakpoints
Pumps 2.7
Basic Setup
Modifiers
Wall Cling Reduction
* Energy Savings
* Pump Run-On
* Pump Start Delays
* Totalizers
Alarms 2.8
High Level Alarm
Low Level Alarm
Switch (DI) Alarm
In-bounds Level Alarm
Out-of-bounds Level Alarm
Low Temperature Alarm
High Temperature Alarm
Fail-safe Fault Alarm
* High Flowrate Alarm
* Low Flowrate Alarm
Relay Logic
Time to Spill
To Next Page
Loading...
