A5E33701270 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL Page 69
mmmmm
Operation - AMS
Reset
• Perform a master reset, reset of configuration flag (for HART
communications), min/max temperatures, and totalizers
Setup
Navigate to Configure/Setup > Setup for access to:
Sensor
• Set primary and secondary sensor mode, units, transducer, frequency and
shot durations
Calibration
• Set high and low calibration points, sensor offset, near and far ranges
Fail-Safe
• Set fail-safe value, material level, and LOE timer
Current Output
• Set current output function, and mA limits and scale values
Volume
• Allow volume calculation through setup of units, vessel shape and
dimensions
To Next Page
Loading...
