A5E33701270 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL Page 83
mmmmm
Operation - AMS
K Factor
Roughness Coefficient
Slope
OCM Dimension 1
OCM Dimension 2
OCM Dimension 3
OCM Dimension 4
Units
Low Calibration Point
High Calibration Point
Response Rate
Maximum Head
Flowrate Units
Flowrate Decimal
Low Flow Cutoff
Maximum Flow at 20 mA
Sensor Mode
Current Output Function
Start of Scale (= 4 mA)
Full Scale (= 20 mA)
Wizard - Pump Control
Step 1 of 4: Application (tab)
Pump Control Enable 2.7.1.1
Relay Pump 1 2.7.1.2
Relay Pump 2 2.7.1.3
Step 2 of 4: Vessel Regime (tab)
Pump Control Mode
Service Ratio Pump 1 2.7.1.10
Service Ratio Pump 2 2.7.1.11
Step 3 of 4: Pump Setpoints (tab)
ON Setpoint Pump 1 2.7.1.6
OFF Setpoint Pump 1 2.7.1.7
ON Setpoint Pump 2 2.7.1.8
OFF Setpoint Pump 2 2.7.1.9
Step 4 of 4: Summary (tab)
Pump Control Enable
Relay Pump 1
Relay Pump 2
Pump Control Mode
Service Ratio Pump 1
Service Ratio Pump 2
ON Setpoint Pump 1
Configure/Setup Function Group (cont’d)
parameter
number
To Next Page
Loading...
