Siemens SITRANS LUT400 - Page 91

A5E33701270 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL Page 87
mmmmm
Operation - AMS
Totalizers (tab)
Long TAG 3.1.2
Running Totalizer 2.7.3.1
Totalizer Decimal Position 2.7.3.2
Totalizer Multiplier 2.7.3.3
Inflow/Discharge Adjust 2.7.3.4
Alarms
Level
Level (tab)
Long TAG 3.1.2
(High Level Alarm) Enable 2.8.1.1
High Level Value On 2.8.1.2
High Level Value Off 2.8.1.3
Assigned Relay 2.8.1.4
Alarm State 2.8.1.5
(In-bounds Level Alarm) Enable 2.8.4.1
High Level Value 2.8.4.2
Low Level Value 2.8.4.3
Assigned Relay 2.8.4.4
Alarm State 2.8.4.5
(Low Level Alarm) Enable 2.8.2.1
Low Level Value On 2.8.2.2
Low Level Value Off 2.8.2.3
Assigned Relay 2.8.2.4
Alarm State 2.8.2.5
(Out-of-bounds Level Alarm)
Enable
2.8.5.1
High Level Value 2.8.5.2
Low Level Value 2.8.5.3
Assigned Relay 2.8.5.4
Alarm State 2.8.5.5
Alarms (tab)
Long TAG 3.1.2
(Low Temperature Alarm) Enable 2.8.6.1
Low Temperature Value On 2.8.6.2
Low Temperature Value Off 2.8.6.3
Assigned Relay 2.8.6.4
Alarm State 2.8.6.5
(High Temperature Alarm) Enable 2.8.7.1
High Temperature Value On 2.8.7.2
High Temperature Value Off 2.8.7.3
Assigned Relay 2.8.7.4
Configure/Setup Function Group (cont’d)
parameter
number