Siemens SITRANS LUT400 - Page 92

Page 88 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL A5E33701270
mmmmm
Operation - AMS
Alarm State 2.8.7.5
(Switch DI Alarm) Enable 2.8.3.1
Discrete Input Number 2.8.3.2
Discrete Input State 2.8.3.3
Assigned Relay 2.8.3.4
Alarm State 2.8.3.5
(Fail-safe Fault Alarm) Enable 2.8.8.1
Assigned Relay 2.8.8.2
Alarm State 2.8.8.3
Relay 1 Logic 2.8.11.1
Relay 2 Logic 2.8.11.2
Relay 3 Logic 2.8.11.3
Level To Spill 2.8.12.1
Minutes Left To Spill 2.8.12.2
Flowrate (tab)
Long TAG 3.1.2
(High Flowrate Alarm) Enable 2.8.9.1
High Flowrate Value On 2.8.9.2
High Flowrate Value Off 2.8.9.3
Assigned Relay 2.8.9.4
Alarm State 2.8.9.5
(Low Flowrate Alarm) Enable 2.8.10.1
Low Flowrate Value On 2.8.10.2
Low Flowrate Value Off 2.8.10.3
Assigned Relay 2.8.10.4
Alarm State 2.8.10.5
Discrete Inputs (tab)
Long TAG 3.1.2
(Backup Level Override) Enable 2.9.1.1
Level Override Value 2.9.1.2
Discrete Input Number 2.9.1.3
Discrete Input 1 Logic 2.9.2.1
Discrete Input 1 Scaled State 2.9.2.2
Discrete Input 2 Logic 2.9.2.3
Discrete Input 2 Scaled State 2.9.2.4
(Pump Interlock) Enable Pump 1 2.9.3.1
Pump 1 Discrete Input 2.9.3.2
(Pump Interlock) Enable Pump 2 2.9.3.3
Pump 2 Discrete Input 2.9.3.4
Data Logging (tab)
Long TAG 3.1.2
(Process Value Log) Enable 2.10.1.1
Configure/Setup Function Group (cont’d)
parameter
number