Siemens SITRANS LUT400 - Alarms

General Operation
7.6 Alarms
SITRANS LUT400
Operating Instructions, 07/2019, A5E33329501-AC
99
7.6 Alarms
7.6.1 Set the common parameters
①
Low level value
②
Material level reading
④
High level value
⑤
Level
⑥
Sensor reference point
⑦
High calibration point
Prerequisite: You must know the details of your application and substitute the values for the
sample values provided. If you are bench testing the device, then set your test values to be
the same as the sample values.
Parameter
Description
Sensor Mode (2.1.2.) (Page 168)
or
Sensor Mode (2.1.3.) (Page 169)
LEVEL
FLOW
Response Rate in Quick Start (Page 59)
MEDIUM
Transducer (2.1.6.) (Page 170)
XPS-10
Units (2.1.1.) (Page 168)
M
Flowrate Units (2.15.3.7.) (Page 233)
L/S
Low Calibration Point (2.2.1.) (Page 171)
1.8
High Calibration Point (2.2.2.) (Page 172)
0.4
Note
When configuring alarms, more than one alarm can be assigned to the same relay.