Siemens SITRANS LUT400 - Delete Logs (2.10.5.); Other Control (2.11.)

SITRANS LUT400
212 Operating Instructions, 07/2019, A5E33329501-AC
Standard Flow Log Interval (2.10.4.3.)
Sets standard flow log interval in minutes, when Flow Log Mode (2.10.4.1.) (Page 211) set to
a fixed or variable rate.
Values
Range: 1 to 1440
Default: 1
Standard Flow Log Setpoint (2.10.4.4.)
Sets standard flow setpoint as a percent based on flow log mode, when Flow Log Mode
(2.10.4.1.) (Page 211) set to a variable rate.
Values
Range: 0.000 to 110.000
Default: 0.000
Rapid Flow Log Interval (2.10.4.5.)
Sets rapid flow log interval in minutes, when Flow Log Mode (2.10.4.1.) (Page 211) set to a
variable rate.
Values
Range: 1 to 1440
Default: 1
Rapid Flow Log Setpoint (2.10.4.6.)
Sets rapid flow setpoint as a percent based on flow logger mode, when Flow Log Mode
(2.10.4.1.) (Page 211) set to a variable rate.
Values
Range: 0.000 to 110.000
Default: 0.000
9.2.10.5 Delete Logs (2.10.5.)
Select YES to permanently delete all data logs in the LUT400.
Options
NO
YES
9.2.11 Other Control (2.11.)
Note
Default settings in the parameter tables are indicated with an asterisk (*) unless explicitly
stated.