Siemens SITRANS LUT400 - Page 318

SITRANS LUT400
316 Operating Instructions, 07/2019, A5E33329501-AC
2.14.3.6 ENDING DAY
2.14.3.7 ENDING MONTH
2.15 FLOW (LUT430, 440 only)
2.15.1 PRIMARY MEASURING DEVICE
2.15.2 AUTO ZERO HEAD
2.15.3 BASIC SETUP
2.15.3.1 METHOD OF FLOW CALCULATION
2.15.3.2 FLOW EXPONENT
2.15.3.3 MAXIMUM HEAD
2.15.3.4 MAXIMUM FLOW AT 20MA
2.15.3.5 ZERO HEAD OFFSET
2.15.3.6 FLOWRATE DECIMAL
2.15.3.7 FLOWRATE UNITS
2.15.3.8 USER DEFINED UNIT
2.15.3.9 LOW FLOW CUTOFF
2.15.4 PMD DIMENSIONS
2.15.4.1 K FACTOR
2.15.4.2 V NOTCH ANGLE
2.15.4.3 SLOPE
2.15.4.4 ROUGHNESS COEFFICIENT
2.15.4.5 OCM DIMENSION 1
2.15.4.6 OCM DIMENSION 2
2.15.4.7 OCM DIMENSION 3
2.15.4.8 OCM DIMENSION 4
2.15.5 UNIVERSAL HEAD VS FLOW
2.15.5.1 TABLE 1-8
2.15.5.2 TABLE 9-16
2.15.5.3 TABLE 17-24
2.15.5.4 TABLE 25-32
2.16 TOTALIZERS (LUT430, 440 only)
2.16.1 DAILY TOTALIZER
2.16.2 RUNNING TOTALIZER
2.16.3 TOTALIZER DECIMAL POSITION
2.16.4 TOTALIZER MULTIPLIER
2.16.5 RESET DAILY TOTALIZER
2.16.6 RESET RUNNING TOTALIZER
3. MAINTENANCE AND DIAGNOSTICS
3.1 IDENTIFICATION
3.1.1 TAG
3.1.2 LONG TAG
3.1.3 DESCRIPTOR