Siemens SITRANS LUT400 - Quick Start Wizards

Commissioning
6.3 Quick Start Wizards
SITRANS LUT400
Operating Instructions, 07/2019, A5E33329501-AC
57
1. Navigate to the desired parameter.
2. When selected, the current value is displayed.
3. Press RIGHT arrow to open Edit mode. The cursor position is highlighted.
4. Use LEFT and RIGHT arrow to move cursor to digit position you wish to change.
5. As each digit is highlighted (selected), use the
UP and Down arrow to increase or
decrease the digit respectively.
6. While decimal point is selected, use UP and Down arrow to shift decimal position.
7. To escape without saving your changes, press LEFT arrow continually until ESC is
highlighted. Press
LEFT arrow again to escape without saving changes.
Otherwise, when new parameter value is correct, press RIGHT arrow continually until
OK is highlighted.
8. Press RIGHT arrow to accept the new value.The LCD returns to parameter view and
displays the new selection. Review for accuracy.
Key functions in Edit mode
Key
Name
Function
UP
or
DOWN
arrow
Selecting options Scrolls to item.
Alphanumeric
editing
- Increments or decrements digits.
- Toggles plus and minus sign.
RIGHT arrow
Selecting options - Accepts the data (writes the parameter).
- Changes from Edit to Navigation mode.
Numeric editing - Moves cursor one space to the right.
- or with selection highlighted, accepts the data and
changes from Edit to Navigation mode.
LEFT arrow
Selecting options
Cancels Edit mode without changing the parameter.
Numeric editing - Moves cursor to plus/minus sign if this is the first
key pressed.
- or moves cursor one space to the left.
- or with cursor on Enter sign, cancels the entry.
6.3 Quick Start Wizards
A Wizard provides an easy step-by-step Quick Start (QS) procedure that configures the
device for a simple application. To configure the SITRANS LUT400 for applications of level,
volume (standard vessel shapes), or flow, use the Quick Start Wizards via LUI (Page 58) of
this chapter.
Wizards for applications employing more complex vessel shapes are available via SIMATIC
PDM. See Quick Start (Volume - Linearization) in the LUT400 Communications manual.