Siemens SITRANS LVL200E - Exchanging the Electronics Module

31
MAN-100411
SITRANS LVL200E - Operating Instructions
55328-EN-170712
Depending on the reason for the fault and the measures taken, the
steps described in chapter "Set up" may have to be carried out again.
7.3 Exchanging the electronics
If the electronics module is defective, it can be replaced by the user.
In Ex applications only an electronics module with respective Ex ap-
proval may be used.
Youcanndalltheinformationyouneedtocarryoutanelectronics
exchange in the handbook of the new electronics module.
In general, all electronics modules of series SW60 can be inter-
changed.Ifyouwanttouseanelectronicsmodulewithadierent
signaloutput,youcarryoutthecompletesetup.Youndtheneces-
sary, suitable operating instruction on our homepage.
Note:
Keep in mind that enamelled instrument versions need special
electronics modules. These electronics modules are called SW60E or
SW60E1.
7.4 How to proceed if a repair is necessary
If it is necessary to repair the instrument, please con-
tactSiemens.Youndthelocationsonourhomepage
"www.siemens.com/processautomation".
Reaction after fault recti-
cation