Siemens SITRANS MAG 6000 I - Sensor Characteristics; A.11 Sensor Characteristics

A.11 Sensor characteristics
*
6HQVRU
FKDUDFWHULVWLFV
6HQVRUSURP
,QVWDOOHG
,QVWDOOHG
1RWLQVWDOOHG
6XSSUHVV3
6(162535201R
<HV


1R
6HQVRUVL]H
&DOLEUDWLRQIDFWRU
&RUUHFWLRQIDFWRU
([FLWDWLRQ


1) Error status (level or number) on an output is updated only at the time the error status changes
(occurs
or disappears). If P40 is suppressed after it has been detected (at power up), the output
does not change state. In this case the power must be switched off/on to suppress the P40 error
on the output.
2) The frequency can be set to 44 Hz in the MAG 6000 SV transmitter only.
Menu diagrams
A.11 Sensor characteristics
SITRANS MAG 6000 I/6000 I Ex de
Operating Instructions, 08/2018, A5E02083319-AH
83