Siemens sitrans PROBE LU - Condensed Status Codes

Page 20 SITRANS Probe LU (HART) – OPERATING INSTRUCTIONS A5E32337695
Operation
Security
The Lock parameter, P000, secures SITRANS Probe LU against changes via the handheld
programmer. To enable programming, set P000 to the Unlocked Value stored in P069. To
disable programming, enter a different value.
Starting PROGRAM mode
The handheld programmer gives you direct access to SITRANS Probe LU.
Handheld programmer
For direct access to SITRANS Probe LU, point the handheld programmer at the display
from a maximum distance of 600 mm (2 ft), and press the keys.
Activating SITRANS Probe LU
Power up the instrument. SITRANS Probe LU starts in RUN mode, and detects the
material level, displayed in meters, referenced from Empty (process empty level).
Note:
• A remote master can still change configuration, if P799 is set to allow this.
Note: For detailed instructions on using the handheld programmer, see the next page.
Note: Keep infrared devices such as laptops, cell phones, and PDAs, away from
SITRANS Probe LU to prevent inadvertent operation.
display
handheld programmer
Numeric and
Auxiliary keys
Function
Keys
600 mm
(2 ft)