Page 44 SITRANS Probe LU (HART) – OPERATING INSTRUCTIONS A5E32337695
Parameters
P210 4 mA Setpoint (low output)
Sets the process level corresponding to the 4 mA value. 4 mA always defaults to 0, and
P201 determines whether this is a Level, Space, Distance, or Volume (or flow)
1
measurement. Level and Space are measured as a percentage of Span; Distance is
measured as a percentage of Empty.
Enter the reading that is to correspond to a 4 mA output. Use percent or units, depending
on the setting for P051.
P201 (mA Function) Settings Response for P210 and P211
Level, Space, or Distance
Key in the material level in Units (P005) or percent
1
of Span
(P007) as referenced from Empty (P006).
Volume
Key in the volume in Maximum Volume (P051) units or as a
percent
1
of Maximum Volume.
1.
Ensure the % symbol is displayed before entering a % value.
Note: P210 is used to set the 4 mA loop current for the HART common module.
1.
To display flowrate instead of volume, see
P050 Vessel (or Channel) Shape
on
page 35.
Values
Range –99999 to 99999.
Default
0.000 m (set to 0% as defined by
P201: mA Output Function)
Related Parameters
P201: mA Output Function
To Next Page
Loading...
