Installing
4.3 Electric connections non Ex
SITRANS SL
Operating Instructions, 12/2010, A5E01132948-04
47
4.3.1 System set-up (non Ex only)
Install the cables in the transmitter sensor and receiver sensor according to the following
figures.
Non Ex version with sensor connection cable kit
① Transmitter housing ⑨ Large cable gland (for cables with a diameter of
13 ... 18 mm)
② Transmitter tube unit ⑩,
⑪
Small cable gland (for cables with a diameter of
8 ... 12 mm)
③ Process interface ⑬ Reference cell inside the receiver unit
④ Customer flange (not included) ⑭ Remote control
⑤ Purging tube (accessory)
⑥ Receiver tube unit
⑦ Receiver housing
⑧ Connection cable (accessory)
Sensor connection cable kit (accessory) consisting of
⑫ Sensor connection cable
⑮ Receiver junction box
⑯ Receiver junction box cable
⑰ Cable gland for Ethernet cable
Figure 4-5 Connection of a non Ex system using a sensor connection cable kit
To Next Page
Loading...
