28
Control lights do not A fuse has triggered.
Switch on / replace the fuse.
Call Customer Service if this fault is
repeated.
Power failure. An interrupted programme will be
resumed when power returns. If you
wish to unload the laundry, proceed
as in Cleaning the drain pump",
Page 25.
Plug is loose or not inserted.
Programme does not
start.
Loading door not closed.
Check whether laundry is trapped in
door.
The On" control light
flashes.
Close the loading door (a click
should be heard).
Programme does not
start.
3" button not pressed. Press the 3" button.
Water does enter the
machine or detergent is
Water tap not turned on. Turn on water tap.
not washed away.
The Active" control light
flashes.
Strainer in supply hose clogged.
Clean the strainer
(refer to Page 26).
Detergent in chamber is
not washed away.
A programme without Prewash was
selected.
Select "60 °C Cottons/coloureds
with Prewash".
Water cannot be seen in
drum.
This is not a fault.
The water lies below the visible part of the drum.
Washing solution is not
Loose debris is blocking the pump. Clean the pump (refer to Page 25).
completely drained. The
End" control light
flashes.
FluffĆproducing laundry was washed
at a high temperature. The water
drainage pipe or drain hose is
blocked.
Clean the water drainage pipe
and/or drain hose.
Water is flowing out from
underneath the machine.
The thread of the supply hose is not
tight.
Tighten the thread.
Leak in the drain hose. Replace the drain hose.
To Next Page
Loading...
