0.0
syngo CT 2007E Emotion Operator Manual
02/2008
0.0
F.1-1
0.0
CHAPTER
F.0
F.1
General Information
To ensure a constantly high image quality, you must perform
quality measurements regularly.
F.1
After switch on
F.1
Whenever you start the system, you can perform automatic
checks and a series of warm-up scans. (→ Page D.1-8 System
checkup and calibration)
F.1
Regular checks
F.1
Quality tests are usually performed in several steps:
F.1
❏ Daily quality measurements
❏ Monthly quality measurements (constancy test)
❏ Camera test
❏ CTDI test (once every six months)
Phantoms
F.1
Phantoms are used to perform quality measurements. You posi-
tion these phantoms on the patient table prior to these tests.
F.1
To Next Page
Loading...
