Siemens SONOLINE G50 - Unpacking the G50 and the G60 S

Page 2 of 4 7482255 Rev 01 Siemens
October 2002
Unpacking the G50 and the G60 S
1.0 Unpacking the G50 and the G60 S
Figure A-1 presents the packaging methods employed for the G50 and the
G60 S.
1. Cut the shipping straps and tape that hold the external packaging in place.
2. Remove the three plastic clamps.
3. Open and remove the shipping box.
4. Remove the accessories box.
5. Remove the two cardboard ramp supports from under the system.
6. Place the ramp supports on the floor (items 7).
7. Lower the ramp (SLOPE) down onto the ramp supports (items 7).
8. Remove the wrapping from the system.
9. Unlock the wheels of the G50 or the G60 S as shown in Figure A-1.
10. Roll the ultrasound system off of the pallet.
11. Review the packing slip: Verify that all equipment and OEMs indicated on
the packing slip are present.
12. Inspect all of the equipment and report any shipping damage immediately.
13. Verify that the serial numbers of the system, monitor, and options agree
with those listed on the delivery note: Report discrepancies.
14. Unpack the accessories box before beginning the installation and verify
that the following are present in the box:
• Power cord (1)
• Array transducer holder (4)
• Sector transducer holder (1)
• Gel bottle holder (1)
• System software MO diskette (1)
!
Warning: The G50 and the G60 S weigh 130 kg (287 lb) and represents a lifting hazard;
attempting to lift this system manually can cause serious injury. Instructions for lifting the G50
or the G60 S, when enclosed in its shipping container, are provided on the container. Once un-
boxed from the shipping container, neither the G50 nor the G60 S is not designed for lifting;
transport it on its casters.