Page 6 of 52 7482255 Rev 01 Siemens
October 2002
Removing and Installing the Monitor
11. Place the original monitor in a secure location.
12. Unpack the bottom cover, the monitor cover, and items contained in the
accessories package (Figure 4-4).
13. Remove the replacement monitor from the packaging.
14. Install two M4 X 18 screws into the bottom cover shown in Figure 4-6.
15. Install two M4 X 18 screws into the monitor cover from the direction indi-
cated at the bottom of Figure 4-6.
16. Attach the mounting hardware to the replacement monitor shown in
Figure 4-7, reusing the two hexagon socket head bolts that were removed
from the original monitor.
Figure 4-6 Monitor and Post Attachment
!
Warning: The improper installation of the threaded fasteners and the mounting hardware that
support the monitor can create a potential hazard. The monitor is heavy and could cause seri-
ous injury. Always verify that the fasteners that attach the monitor are tightened securely so that
the monitor will not loosen and fall.
To Next Page
Loading...
