Siemens SONOLINE G50 - Confirming the Operation of the Color Printer; Confirming the Operation of the VCR

Page 22 of 52 7482255 Rev 01 Siemens
October 2002
Installing the Color Printer and the VCR
4.4 Confirming the Operation of the Color Printer
1. Ensure that the cables are connected correctly according to Figure 4-15.
2. Verify that the RGB IMPEDANCE switch is set to 75 _/HIGH and that the
SYNCHRONIZATION SIGNAL IMPEDANCE switch is set to HIGH.
3. Connect the system power cable to a properly grounded outlet.
4. Connect a transducer to the G50 or the G60 S.
5. Turn the power switch On.
6. Turn the Standby switch On.
7. Confirm that a B-mode image is displayed on the monitor.
8. Turn on the power switch of the CP900.
9. Press F4 to display the Menu screen on the monitor.
10. Move the trackball upward and select Customize Keys from the sub
menu.
11. Press SET.
12. Select Color Print for Set Up for PRINT/STORE 2 and press SET.
13. Select Save and press SET.
14. Press the MENU key on the CP900 remote control.
15. Select Signal Set and set the Input to RGB.
16. Press PRINT 2.
17. Confirm that the B-mode image on the monitor is printed correctly by the
CP900.
4.5 Confirming the Operation of the VCR
1. Ensure that the cables are connected correctly according to Figure 4-18.
2. Confirm that the number 3 and the number 5 DIP switches are set in the On
position.
3. Connect the system power cable to a properly grounded outlet.
4. Connect a transducer to the G50 or the G60 S.
5. Turn the power switch On.
6. Turn the Standby switch On.
7. Confirm that a B-mode image is displayed on the monitor.
8. Turn on the SVO-9500 power switch and insert a S-VHS tape into the VCR.
9. Press F4 to display the Menu screen on the monitor.
10. Move the trackball upward and select Peripheral from the sub menu.
11. Press SET.