Page 38 of 52 7482255 Rev 01 Siemens
October 2002
Removing and Installing the MO Drive
14. Move to the front side of the G50 or the G60 S and pull off the sub control
panel.
15. Press and release the hooks on both sides of the ribbon cable connector,
and disconnect the cable from CN2 on the reverse of the sub control panel.
16. Hold the MO drive with your hand, inserting one hand from the rear side of
the G50 or the G60 S, while removing the screws from the MO drive bay.
Figure 4-32 Removing the Monitor Post Cover
Figure 4-33 Removing the Sub Control Panel (LCD)
!
Caution: When the four screws are removed from the MO drive bay, the bay can
fall free. Use caution, holding the MO drive bay securely, to prevent if from drop-
ping and being damaged.
To Next Page
Loading...
