Page 2 of 16 7482255 Rev 01 Siemens
October 2002
Installing the G50 DIMAQ-IP
1.0 Installing the G50 DIMAQ-IP
Use the following methods to install the DIMAQ-IP module on the G50.
See "Removing and Installing the DIMAQ-IP Module" (page 4-24) for remove
and replace procedures appropriate for both the G50 and the G60 S DIMAQ-IP
module.
1.1 Tools Required
Use the following tools to install the DIMAQ-IP option:
Phillips screwdriver (#1)
Phillips screwdriver (#2)
Straight-blade screwdriver (.25 inch)
Side cutters
1.2 Kit Contents
Verify that the DIMAQ-IP kit contains the items listed in Table 5-1.
Note: The G50 was released with version 1.2 of the system software installed.
The DIMAQ-IP option requires this version 1.2 system-software revision level as
a minimum.
!
Caution: Static sensitive components and connectors are exposed during this
procedure. Electrostatic discharge (ESD) can damage or destroy electronic
components. Use proper ESD protective procedures during the performance of
this procedure.
Table 5-1
Item Part
Number
Quantity
DIMAQ-IP module
(a)
7478683 1
A70-2 PPCL
(b)
PCB 7479913 1
M3 X 6 screw 4
M2.5 X 6 screw 2
External lock washer 2
Wire Ties 3
Ethernet cable (straight) 1
Ethernet cable (cross) 1
USB cable 1
VGA cable 1
Serial cable 1
Option label 1
To Next Page
Loading...
