Siemens SSE161.05U - Manual Stem Adjustment; Wiring and Cabling

6
Siemens
A6V12681514_enUS_b
Smart Infrastructure
06/15/2023
To move the actuator stem manually
1. Open the cover using a proper screwdriver.
2. Press and hold down button (a) illustrated below for at least three seconds.
– The actuator ignores any control signal from the controller.
3. Adjust the position of the actuator stem by rotating hexagonal wrench (b) illustrated
below clockwise or counter-clockwise.
– The actuator stem moves down if you rotate clockwise; it moves up if you rotate
counter-clockwise. The manually set position is retained.
4. To exit manual operation mode, press and hold down button (a) illustrated below again
for at least three seconds.
– The actuator runs a self-calibration automatically. Control signal sent from the
controller takes effect.
5. Close the cover.
NOTICE
If operating voltage is applied to actuator, press button (a) before and after manually
adjusting the position of the actuator stem. If no operating voltage and control signal are
applied, manual operation can be done without pressing button (a).
Cabling operation
1. Unscrew cover screw
2. Remove cover
3. Connect or disconnect wire terminals (terminal block is removable)
4. Install the cover
5. Screw in the cover screw
A
6
V
1
1
8
5
8
2
7
8
Z
1
0
3 mm
(b)
(a)
> 3s