Maintenance
The actuators require no maintenance.
Operating voltage must be switched off during any maintenance!
When carrying out service work on the plant, note the following:
● Switch off operating voltage.
● If necessary, disconnect electrical connections from the terminals.
● The actuator must be commissioned only with a correctly mounted valve in place!
Repair
The actuators cannot be repaired; the complete unit must be replaced.
Disposal
The device is considered an electronic
device for disposal and may not be disposed
of as domestic waste.
● Dispose of the device through channels
provided for this purpose.
● Comply with all local and currently
applicable laws and regulations.
Warranty
Technical data on specific applications are valid only together with Siemens products listed
under "Equipment combinations". Siemens rejects any and all warranties in the event that
third-party products are used.
Open Source Software (OSS)
Software license overview
These devices use Open Source Software (OSS). All Open Source Software components
used in the product (to include copyrights and licensing agreement) are available at
http://siemens.com/bt/download.
Readme OSS for Modulating Room Actuator 200 N, 300 N
To Next Page
Loading...
