Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
Security classification
property name.
Page
23 of 73
Version 008
Status
Released
Last Editor Nathan Fearnhead
Date
16/06/2017
Document Name Configuration Control
Document No.
667/CC/32750/000
Copyright © Mobility 2017. All Rights Reserved. Mobility is a division of Siemens Plc
3.7 Detector Cards and Intelligent Detector Backplanes PCBs
Intelligent Detector Backplanes and Detector Cards do not form part of the base Controller
Cabinet and therefore should be specified separately. Figure 18 provides a listing of required
components.
3.7.1 Intelligent Detector Backplane in 400S Small Outercase
The ST750ELV Small Outercase can be specified with one of two different swing frame
configurations. Both options CANNOT fit in the 400S Small Outercase together.
On those occasions when four or less Intelligent Detector Cards are to be specified, sufficient
room is available, for the one necessary Intelligent Detector Backplane, in the Gemini/Detector
Swing Frame. Please refer to Figure 2, Figure 3 and Figure 18 and Paragraph 3.2
for more information.
Please note; if required, Single Detector Backplanes may be specified please refer to
paragraph 3.7.3 (667/1/15990/003).
The bottom portion of the Detector Swing Frame accommodates an Intelligent Detector
Backplane. A Gemini
2
unit can be mounted on the top portion of the Detector Swing Frame.
Figure 14 Figure 15 and Figure 14
Figure 15 show the Detector Swing Frame. Example Intelligent Detector
Backplane, Detector Cards and Gemini
2
Unit are shown. Please refer to paragraph 3.9 for further
information on Gemini
2
specification.
Figure 14 Figure 15
Front view of Gemini/Detector Swing Frame Rear view of Gemini/Detector Swing Frame
Warning! Figure 14 Figure 15 and Figure 14
Figure 15 show a Gemini unit, full configuration
details of which are detailed later in this document. It is important that the Gemini Last
Please
note the
SLD4
Detector
is a direct
replaceme
nt for the
ST4S
To Next Page
Loading...
