Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
Security classification
property name.
Page
65 of 73
Version 008
Status
Released
Last Editor Nathan Fearnhead
Date
16/06/2017
Document Name Configuration Control
Document No.
667/CC/32750/000
Copyright © Mobility 2017. All Rights Reserved. Mobility is a division of Siemens Plc
be provided with at least one 11” Detector Rack Kit for the Intelligent Detector Back Planes and
one for a Gemini² Unit. To specify this requirement please refer to Figure 78.
Figure 76
Gemini/Detector Swing Frame
Warning! Figure 76 shows a Gemini² unit, full configuration details of which are detailed
later in this document. It is important that the Gemini² Last Gasp Dial Battery, within the
Gemini² Power Supply Unit, is orientated correctly; the battery terminal must be facing
up. If the unit is to be mounted in such a way that the battery terminals are not facing up then it is
necessary to implement certain modifications to ensure that the battery is not operating upside
down. Please refer to document 667/HB/32600/000 for the necessary modifications.
Figure 77
Detector Cards mounted to 11” Swing Frame
Warning! Figure 77 shows a Gemini² unit, full configuration details of which are detailed
later in this document. It is important that the Gemini Last Gasp Dial Battery, within the
Gemini Power Supply Unit, is orientated correctly; the battery terminal must be facing up.
If the unit is to be mounted in such a way that the battery terminals are not facing up then it is
11” Detector
Rack Kit
Gemini² Unit
SLD4
replaces
ST4S
shown
SLD4
replaces
ST4S
shown
To Next Page
Loading...
