ST750 GENERAL HANDBOOK
667/HB/33750/000 Page 13 Issue 6
• Personnel should also comply with the Highways National Sector Scheme
Competency Requirements
Training requirements for non UK users may be different
1.4.2 REQUIRED TOOLS
In addition to a standard Engineer’s tool kit, the following tools are required when
carrying out any work on the ST750 Controller:
Serial handset Techterm, or
Larger Screened Oyster handset
Manual Panel key Type 900
The ST750 Rack Assembly installed in the ST750 Cabinet with
associated equipment mounting frame, mounting stool, mains
distribution, power supplies, electronic control and phase switching.
Configuration
data (also
referred to as
customer’s
data)
and site
specification
Data supplied by customer as to how the ST750 is to function.
Controller identification number (ElectroMatic).
This goes on the Main Processor Board.
A group of Red, Amber and Green traffic signals plus their
associated Red Man, Green Man and Waits of the pedestrian
signals.
This consists of a box like frame with a plate hinge on the front that
acts as an access door. The Phase Drive PCB and PSU are mounted
behind the ST750 CPU PCB.
To Next Page
Loading...
