Siemens Synco 200 - Operating Texts Synco 200

13.2 Operating texts Synco 200
Operating text Explanation
°C Degrees Celsius
°F Degrees Fahrenheit
%OPEN Outside temp-dependent open
0.0 Universal 000.0
0000 Universal 0000
0-10 DC 0...10 V
2xNI
3P
3-position
3-POINT 3-position output
A Basic type A room temp
ACCESS Access levels
ACK Fault acknowledgement
ACTING Control loop with risk of frost
ACTTIME Actuator running time
ADAP Plant type adapted
ALM OFF Fan release relay
AO Modulating output
APPL ID Basic configuration
CAS/CON Casc/const changeover input
CASC Cascade
CAUTION NEW Caution! New configuration
CH OVER 2-pipe heating/cooling system
CLOS Closing
CLSD Closed
CMF Comfort
CMP1D [Setp compensation 1] delta
CMP1END [Setp compensation 1] end
CMP1STT [Setp compensation 1] start
CMP2D [Setp compensation 2] delta
CMP2END [Setp compensation 2] end
CMP2STT [Setp compensation 2] start
CNST Constant
CO SEQ1 Change to sequence 1
CO SEQ2 Change to sequence 2
CO SEQ4 Change to sequence 4
CO SEQ5 Change to sequence 5
COMMIS Commissioning
CONFIG Extra configuration
COOL Cooling
COOLER Cooling coil valve
CORR Correction
CTL1 Controller 1
CTL2 Controller 2
CTLOOP 1 Controller 1
CTLOOP 2 Controller 2
DIFF Differential input
DIG Frost protection unit
DIG Digital
DLY OFF Switch-off delay
DMP Mixing damper
DV ALM Deviation message
DV DLYH Deviation message delay high
DV DLYL Deviation message delay low
ECO Economy
ERC Heat recovery equipment
FROST Frost protection
FRST Frost protection
HEAT Heating
HREC Mixing damper/HR
INFO
IN X
Preselection external
INVALID Caution! Invalid settings
153 / 174
Siemens Universal Controllers RLU2… CE1P3101en
Building Technologies Appendix 29.08.2008