Siemens Synco 200 - Page 154

O perating texts Synco 200 (cont’d)
INVERS Inversion
KICK Kick period
LABEL Input identifier
LIM General limit controller
LIM DHI Gen limiter differential high
LIM DLO Gen limiter differential low
LIM MAX Gen limiter limit value high
LIM MIN Gen limiter limit value low
LIM TN Gen limiter integr action time Tn
LIM XP Mixing valve P-band Xp
LOCK S1 [Sequence 1] outside temp >
LOCK S2 [Sequence 2] outside temp >
LOCK S4 [Sequence 4] outside temp >
LOCK S5 [Sequence 5] outside temp >
MAIN Main controlled variable
MAINALM Main contr var sensor error
MAT Mixed air temperature
MAT XP Mixed air temp P-band Xp
MAT TN Mixed air temp int act time Tn
MAX Limitation max
MAX Maximum
MAX POS Positioning signal max
MAX VAL Value high
MECH 1 MECH input 1
MECH 2 MECH input 2
MECHSET MECH limit value
MIN Limitation min
MIN Minimum
MIN POS Positioning signal min
MIN VAL Value low
MODE Operating mode
NI Passive Ni1000
NO No
NO None
NORMPOS Normal position
OFF Off
OFF TN Plant OFF Tn
OFF XP P-band Xp
OFFTIME Locking time
OFF-Y Load-dependent OFF
OHM
OK
ON
On
ON DLY Startup delay
ON-OUTS Outside temp-dependent ON
ON-Y Load-dependent ON
OPEN Opening
OPEN Open
OPMODE Preselected optg mode input
ORIG Plant type original (not adapted)
OUTS Outside temperature
OUTSIDE Actual value outside temp
PASS Password level
PASSWRD Enter password
PASSWRD Password
PRIO CH Run priority changeover
PRT Protection
PT
PUMP 1
Pump 1
PUMP 2 Pump 2
PUMP 3 Pump 3
REM1 [Controller 1] rem setp adj
REM2 [Controller 2] rem setp adj
154 / 174
Siemens Universal Controllers RLU2… CE1P3101en
Building Technologies Appendix 29.08.2008