1 Keep the jogwheel turned to move the patient table up/into or
down/out of the magnet bore.
Depending on how far the jogwheel is turned, the speed increases.
The table movement stops immediately once you release the
jogwheel.
2 Press the jogwheel for one second to move the patient table into
the Center Position.
Depending on the situation, you can also move the table
horizontally into the Last Scan Position or the Default Position by
pressing this jogwheel.
Pressing the jogwheel during an automatic table movement
(e.g., to the Home Position) stops the table immediately. Turning
the jogwheel in this case adjusts the speed and movement
direction according to the jogwheel position.
◆ Press the corresponding button to move the patient table into the
required position.
The Table Up/Inward and the Table Down/Outward button can
be pressed in two stages for horizontal movements. Pressing the
button softly moves the table slowly. Pressing the button
forcefully moves the table more quickly.
Pressing one of these buttons during an automatic table
movement (e.g., to the Home Position) stops the table
immediately.
Using the jogwheel
Using the buttons
MR system components 3
MAGNETOM Skyra
fit
| syngo MR E11
61
Print No. M6-04401.621.02.02.02
To Next Page
Loading...
