Fire Safety & Security Products
Building Technologies
1583_o_en_−−_5
95
08.2005
5.16.1 Linking 3. link DRIVER OUT’s and 4. link RELAY OUT’s
Submenu 4. addressable line
to define line type, number of devices, link devices
to define device parameters
to define zone parameters
to define element parameters
to link conventional lines to zone (if available)
to check configuration before exit the programming mode
to delete all user data
to read actual line configuration as installed
to define control outputs
CONFIGURATION 1. line
(c) 2. device
3. zone
4. element
5. line ’collective’
6. CHECK configuration
7. CLEAR configuration
8. AUTOM. configuration
9. CONFIG ConTrol−ZONES
Driver Output no. ## selected driver output number (1..8/..12/..16/..20)
linked to ConTrol zone ### depending on equipped hardware cards
(c.9.3) 1. link to link unlinked driver outputs
2. unlink to unlink alredy linked driver outputs
CONFIGURE: 1. ConTrol ZONES
(c.9) 2. ConTrol ELEMENTS
3. link DRIVER OUT’s link driver outputs
4. link RELAY OUT’s
5. link LON OUT’s
Relay output # selected relay output number (1..8)
linked to ConTrol zone ### only possible with relay card K3G050
(c.9.4) 1. link to link unlinked relay outputs
2. unlink to unlink alredy linked relay outputs
CONFIGURE: 1. ConTrol ZONES
(c.9) 2. ConTrol ELEMENTS
3. link DRIVER OUT’s
4. link RELAY OUT’s relay outputs
Note:
The linking of the addressable output devices to the conTrol zone is done under level ‘Line’.
The linking of outputs on the LON-bus can only be done by the configuration tool SWE330A
To Next Page
Loading...
