EasyManua.ls Logo

Siemens TE603 - Page 28

Siemens TE603
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
en
Problem Cause Solution
Thecoffeetastes“burnt”. Thebrewingtemperatureis
toohigh
Reducethetemperature,
seethesection
“Menu–Coffee temperature”.
Thegrindingsettingis
tooneorthepre-ground
coffeeistoone.
Adjustthegrindingunittoa
coarsersettingorusecoarser
pre-groundcoffee.
Unsuitabletypeofcoffee. Changethetypeofcoffee.
Thewaterlterdoesnot
stayinpositioninthe
watertank.
Thewaterlterisnot
mountedcorrectly.
Firmlypressthewaterlter
straightdownintothetank
connection.
The coffee grounds are
notcompactandaretoo
wet.
Thegrindingsettingistoo
neortoocoarse,ornot
enough ground coffee has
beenused.
Adjustthegrindingunittoa
coarserornersetting,oruse
2levelmeasuringspoonsof
groundcoffee.
Waterdrippedontothe
innerooroftheappli-
ancewhenthedriptray
wasremoved.
Driptraywasremovedtoo
soon.
Waitafewsecondsafterthe
lastdrinkwasdispensedbefore
removingthedriptray.
Displayshows
Please refill bean container
althoughthecontaineris
alreadyfull,orthegrinder
isnotgrindinganybeans.
Beansarenotfallinginto
thegrindingunit(beanstoo
oily).
Gentlytapthebeancontainer.
Possiblychangethetypeof
coffeeused.Whenthebean
containerisempty,wipeitwitha
drycloth.
Displayshows
Please empty drip tray
despitethedriptraybeing
empty.
Emptyingisnotdetected
whentheapplianceis
switchedoff.
Whentheapplianceisswitched
on,removeandre-insertthe
driptray.
Thedriptrayissoiled. Cleanthedriptraythoroughly.
Displayshows
Refill with still water or
change filter
Watertankwrongly
inserted.
Insertwatertankcorrectly.
Carbonatedwaterinthe
watertank.
Fillthewatertankwithfreshtap
water.
Floatisstuckinthewater
tank.
Removethetankandclean
thoroughly.
Newwaterlterdidnot
rinseaccordingtothe
instructions.
Rinsethewaterlteraccording
toinstructionsandthenswitch
on.
Airinthewaterlter. Dipthewaterlterintowater
untilnomoreairbubbles
escape,replacethelter.
Waterlterisold. Insertanewwaterlter.
If you are unable to solve the problem, always call the hotline!
You will nd the telephone numbers at the back of these instructions.

Table of Contents

Related product manuals