en Trouble shooting
26
--------
' LED flashes and all bever-
age LEDs flashing.
Water tank is missing or not
inserted correctly.
Insert water tank correctly.
The pipe system in the appli-
ance is dry.
Insert water tank correctly.
Fill the water tank with fresh tap water.
Do not fill with carbonated water.
Air in the water filter. Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~ "Inserting or replacing a water
filter" on page 16
All LEDs flashing. Incorrect voltage in building. Only operate the appliance at
220V-240V.
', ( and calc’nClean LEDs
flashing.
The ambient temperature is too
cold.
Operate the appliance at temperatures
> 5 °C.
( and % LEDs flashing. Brewing unit very heavily soiled
or brewing unit cannot be
removed.
Clean brewing unit if possible and
switch appliance off and back on
again.
% LEDs flashing. Fault in the appliance. Restart appliance.
calc’nClean and ) light up. The descaling process has
been interrupted.
Continue the descaling process.
~ "Service programme" on page 21
Display "calc'nClean" keeps on
appearing.
The water is too hard. Insert water filter and activate accord-
ing to the instructions. ~ "Water
filter" on page 16
If you are unable to solve the problem, always call the hotline.
You will find the telephone numbers at the back of these instructions
To Next Page
Loading...
