For more technical support, please go to our website:
www.gillardcutting.com/technical
5
2.1.1 Cutter Safety
The cutter has its own independent safety function that will allow sliding away the
cutter block and still be able to drawing product through the machine with the belts.
When any part of the cutter safety function is activated, the pop-up below, left will be
displayed on the home screen. This will indicate the safety circuit is not complete.
When the safety circuit is complete, the pop-up below, right will be displayed, again
the blue rest button will ash.
Simply press the blue button to reset the safety function and allow the cycle to
continue.
The button is designed to be pressed for approximately ½ second before resetting.
The Cutter Safety pop-up is located on the home screen:
To Next Page
Loading...
