Siemens ULTRAMAT 23 - Preparation for Commissioning

Operation
5-31
Operating instructions ULTRAMAT 23 gas analyzer
C79000-B5276-C216-03
Outputs/Sync/Pump Special Functions Tests Factory Config.
510
Analog outputs Assign relays Sync input Pump ON/OFF modes
5101
Level 2 required
Relays for limits Relays for MR Relays for status Relays for valves
51012
Analog output ranges Output during FCTRL Output during faults
51011
Analog output during faults Meas. value: ZERO
51011c
Analog output during Function control Meas value: ACTUAL
51011b
Analog output Set value:
Range: XX / 20 mA
51011a
Relays for limits Limit 1: relay Limit 2: relay
51012a
Choose component Fault :R- MaintenanceReq.:R- CAL/MEAS :R- FunctionControl:R-
51012c
NNNNN MR relay - NNNNN MR relay - NNNNN MR relay - NNNNN MR relay -
51012b
Sync input Binary inputs
51013
Optional board not found! Return with ESC
Mode of Sync input (press -> to toggle)
:activate CAL relay
51013a
Fault/MaintenanceReq Function control Measuring ranges
Clear logbook
51015b
Function ctrl1:x Function ctrl2:x Function ctrl3:x Function ctrl4:x External faults 1-4 External faults 5-7 Ext. maint.req. 1-4 Ext. maint.req. 5-7 xx MR 1 : xx xx MR 2 : xx xx MR AR : xx Choose component
Clear logbook : XX
Fault1:x Fault2:x Fault3:x Fault4:x Fault5:x Fault6:x Fault7:x Maintenance Req.1: x Maintenance Req.2: x Maintenance Req.3: x Maintennace Req.4: x Maintenance Req.5: x Maintenance Req.6: x Maintenance Req.7: x
Pump at CAL : ON Pump at MEAS: ON
External valves Zero gas: relay - Span gas: relay - Sync : relay -
51012d
a)
b)
Access only for
SIEMENS service personnel
Meas.value neg.: ON
Fig. 5-9 Menu sequence for ”Configuration”