Siemens ULTRAMAT 23 - Commissioning Procedures

Operation
5-32
Operating instructions ULTRAMAT 23 gas analyzer
C79000-B5276-C216-03
Interf. NNNNN mg/m3 Chan.: XX Comp: X I1: +X.XXXXe+X Preset AUTOCAL drift Quantity: XXX Limit : XX %
51022
Interf. NNNNN mg/m3 Chan.: XX Comp. X I2: +X.XXXXe+X Code 1 : XXX Code 2 : XXX Language: italiano
51021
Unit for NNNNN set : mg/m3 MR min: XXXXX -3% MR max: XXXXX +3%
51024c
Codes/language AUTOCAL drift ELAN Fact.dara/res/units
5102
Interference NNNNN Interferences: OFF Interference 1 Interference 2
Warning! Analyzer is set to warm-up mode! press ENTER to cont. press ESC to cancel
51024a
Choose component
Choose component
Load factory data Reset analyzer Change units
51024
ELAN parameters ELAN ext.Interfer. PROFIBUS Parameters
51023
Address : Ident number: 2
51023b
ATTENTION! Data will be overwritten! press ENTER to cont. press ESC to cancel
Channel : XX Name :ULTRAMAT23 Protocol :OFF Sync. zero cal. :OFF
51023a
a)
Test:displ/keys/flow Inputs/outputs Chopper/IR source RAM monitor
5103
Test of display Test of keys Test of flow switch
51031
Test of flow sensor Flow O.K. Press ESC to cancel Test of keys Time left: 29 sec Pressed key: no key Test of display press ESC to cancel
Test of analog output Test of relays Test ext. sol. valve Test of inputs
51032
XXXXX mg/m3 NNNNN ZV XXXXX mg/m3 NNNNNOFF XXXXX mg/m3 NNNNN SV XXXXX % O2 OFF
51032c
Test of relays Relay number: 1 Condition: active press ESC to cancel
51032b
Analog 1: XX.XX mA Analog 2: XX.XX mA Analog 3: XX.XX mA Analog 4: XX.XX mA
51032a
Input CAL/pomp/sync Binary inputs
Optional board not found! Back with ESC Test of inputs Active input: NONE press ESC to cancel
51032d
Test of inputs Active input: NONE press ESC to cancel
b)
Functions for SIEMENS service
Functions for SIEMENS service
e
Const. interference
1
1
Interf. CO 5 mg/m3 C.I.: +X.XXXXe+X Const. interf.: OFF
51023c
Boot FW : 0.2.0
TAG : UTWENTYTHREE Firmware : 2.0.0
PB relay: OFF Diagnosis
Fig. 5-10 Menu sequence for ”Configuration” (continued)