Operation
7.4 Operating modes
ULTRAMAT 23
Manual, 3/2016, A5E37100388-003
99
The analyzer is in measuring mode (see section
Measuring
(Page 96)).
Change from measuring mode to input mode by pressing the
<ENTER
> key.
You first access the main menu. A cursor flashes on the charac-
ter "A" at the left edge of the first line.
You can set the cursor to the start of each line using the <
and <
>
keys. Cursor
movements are cyclic, i.e. if you move
above the top edge of the display, the cursor appears again
in the bottom line, and vice versa.
Call the respective menu item by pressing the <
>
key.
The cursor is located at "P
" when you have pressed the <
>
Now call the "Parameters" submenu by pressing the<ENTER
>
The adjacent display appears in which you will be requested to
enter the code number for code level 1.
You can change the value of the code digit to which the
cursor is pointing using the <
> and <
> keys.
Move to the next position of the code number using the <
>
key.
This function is also cyclic, and the cursor appears at the
first position again when you move it beyond the last
position.
Close the code input by pressing the <
> key.
The initial display of the "Parameters" submenu appears.
> again to call the "Measuring ranges" sub-
To Next Page
Loading...
