3. Configure your meter’s SNMP parameters by selecting the parameter value.
Parameter Range Description
Enable SNMP Yes/no Enables or disables SNMP on your meter.
SNMP Port Number 161 (default) Enter your meter’s SNMP port number.
System contact -
Enter the name of your SNMP system
administrator.
System name - Enter a descriptive name for your meter.
System location - Enter your meter’s location.
Read-only Community
Name
-
Enter the community string used for SNMP
get (read-only) requests.
Read-write Community
Name
-
Enter the community string used for SNMP
set (read/write) requests. NOTE: You can
use the read/write community string for
SNMP get (read-only) requests.
Enable SNMP Traps Enable/disable
Enables or disables SNMP trapping on your
meter.
Enable High Priority
Alarms
Yes/no
Enables trapping of events that create high
priority alarms.
Enable Med Priority
Alarms
Yes/no
Enables trapping of events that create
medium priority alarms.
Enable Low Priority
Alarms
Yes/no
Enables trapping of events that create low
priority alarms.
Report Buffer Size 1–30
Enter the maximum number of trap
messages to be stored before the trap
messages are sent. Traps are sent when
the number of trap messages is equal to or
greater than this value.
Report Hold Time 1–300 seconds
Enter the maximum duration for trap
messages to be held. Trap messages are
sent when the time after a trap event has
occurred is equal to or greater than this
value.
Trap Rcvr1 Addr to Trap
Rcvr4 Addr
-
Enter up to four trap receiver IP addresses,
where trap messages will be sent.
4. Click Apply to configure the meter’s SNMP parameters.
SNMP implementation
MIB files
Your meter is compliant with MIB-II as defined by the standard MIB file RFC 1213.
9810 series - User manual Communications
7EN05-0390-08 120
To Next Page
Loading...
