Siemens US2:9810RC - Input;Output ION Modules, Ports, and Labels; Factory Configured Settings

Inputs/Outputs 9810 series - User manual
129 7EN05-0390-08
•
Analog output: uses the Analog Output module to deliver a continuous direct voltage or
current analog signal to transducers.
NOTE: All of these modules can act as intermediaries between the physical hardware port and
the other modules in the meter. They define the characteristics of the incoming and outgoing
signals.
Input/output ION modules, ports, and labels
You can configure the Digital Output, Digital Input, Analog Input, Analog Output, Pulser and
Calibration Pulser ION modules to specify which port handles the outgoing or incoming signals.
To assign a port to one of these modules, modify the Port setup register by picking a port from the
enumerated list.
NOTE: If the port you want to use does not appear in the Port setup register list, that port is in
use by another module. Edit the Port setup register of the module using that port and set it to Not
Used. The port is then available to other modules.
Factory configured settings
ION module
type
ION module name Hardware port
(device label)
Port setup
register name
Description
Digital
Output
Port D1–D4 D1–D4 Port D1–D4 Form A relay
Port R1–R2 R1–R2 Port R1–R2 Form C relay
Calibration
Pulser
WATT LED kWATT WATT LED
kW energy pulsing
(total)
VAR LED kVAR VAR LED
kVAR energy pulsing
(total)
Digital Input Port S1–S8 S1–S8 Port S1–S8
Internally/externally
excited
Onboard input and output ports
ION module
type
ION module name Hardware port
(device label)
Port setup
register name
Description
Digital Input Port A/B/C/D S1–S6 S1–S6
Port A S1–S6
Port B S1–S6
Port C S1–S6
Port D S1–S6
Option module
digital inputs
Option module(s) input and output ports